| BELT-Ultimate
140 BOS-Nitrile, impregnated belt with one side brushed.
BED-12 ga. galvanized slider pan mounted in 6-1/2 in.
x 12 ga. powder painted formed steel channel frame bolted together with
splice plates.
CENTER DRIVE-Provides 16 in. of belt take-up. Minimum
elevation- 19-1/2 in. Specify location. Minimum OAL without modification-120
in. Chain guard located on left hand side.
DRIVE PULLEY-8 in. dia. with 1-3/16 in. dia. shaft at
bearings, machine crowned and fully lagged.
TAIL PULLEY-4 in. dia. with 1 in. dia. shaft at bearings
or 6 in. dia. with 1-3/16 in. dia. shaft at bearings, machine crowned.
See chart on Page 10.
SNUB IDLER-Adjustable 2-1/8 in. dia. pre-lubricated ball
bearings. Guards included. |
RETURN IDLER-Adjustable
1.9 in. dia. pre-lubricated ball bearings.
TAKE-UP-Take-up in center drive provides 16 in. of belt
take-up.
BEARINGS-Sealed, pre-lubricated, self-aligning, ball
bearings on drive and tail pulleys.
SPEED REDUCTION-Sealed worm gear C-Face speed reducer.
No. 50 roller chain to drive pulley.
MOTOR-1 HP-230/460V-3 Ph.-60 Hz. Totally Enclosed C-Face.
BELT SPEED-Constant 65 FPM.
CAPACITY-Maximum load per linear foot of conveyor 100
lbs. NOT TO EXCEED capacity in charts.
FLOOR SUPPORTS-Now supplied as optional equipment. |
