| BED - Roller
bed with 1-3/8 in. dia. roller x 18 ga. galvanized tube spaced every 3
in. Mounted in 9-1/2 in. x 12 ga. powder painted formed steel channel
frame bolted together with splice plates.
CROSS BRACING - Rods
with turnbuckles are fastened to underside of bed to provide proper alignment
of bed rollers and insure correct product tracking. Supplied on every
other section, 30 ft. bed lengths and over.
DRIVE - Mounted
underneath, placed near center of conveyor. NOTE: On Conveyors less
than 24 in. OAW, motor extends beyond frame. Chain guard located
on left hand side.
DRIVE SHAFT - 1
in. dia. steel shaft extends full length of conveyor. Chain coupling at
bed joints. Located on left hand side.
DRIVE SPOOLS - 2
in. dia. Delrin spool held in place on drive shaft with spool spacers.
DRIVE GUARD - Underside
of drive shaft with spools and drive o-rings guarded full length of conveyor.
|
DRIVE O-RINGS
- 1/8 in. dia. polyurethane
o-ring from drive spool to tread rollers.
BEARINGS - Sealed,
pre-lubricated, self-aligning, ball bearings with eccentric lock collar
on drive shaft. Pre-lubricated ball bearings in tread rollers.
SPEED REDUCTION -
Sealed worm gear C-Face
speed reducer. No. 50 roller chain to drive shaft.
MOTOR - 1/2
HP - 230/460V
- 3 Ph.–60 Hz.
Totally Enclosed C-Face.
CONVEYING SPEED -
Constant 65 FPM.
CAPACITY - Maximum
load per powered roller 10 lbs. NOTE: Maximum load capacity will
be less for products with soft or irregular bottoms. Total load
NOT TO EXCEED capacity in chart.
FLOOR SUPPORTS -
Now supplied as optional
equipment. |
