| BELT - Ultimate
140 SD - Nitrile
impregnated, thin polyurethane top.
BED - Roller
bed with 1.9 in. dia. roller x 16 ga. galvanized tube spaced every 3 in.
and 1.9 in. dia. pressure roller x 16 ga. galvanized tube spaced every
6 in. Mounted in 6-1/2 in. x 12 ga. powder painted formed steel channel
frame bolted together with butt couplings.
CROSS BRACING - Rods
with turnbuckles are fastened to underside of bed to provide proper alignment
of bed rollers and insure correct product tracking. Supplied on every
other section, 30 ft. lengths and over.
CENTER DRIVE - Can
be placed in any section of conveyor length.
DRIVE PULLEY - 8
in. dia. with 1-3/16 in. dia. shaft at bearings, machine crowned and fully
lagged.
TAIL PULLEY - 4
in. dia. with 1 in. dia. shaft at bearings, machine crowned.
TAKE-UP PULLEY - 4
in. dia. with 1 in. dia. shaft crowned.
SNUB IDLER - Adjustable
2-1/8 in. dia. pre-lubricated ball bearings.
|
RETURN IDLER
- Adjustable 1.9 in.
dia. pre-lubricated ball bearings.
TAKE-UP - Take-ups
in center drive provide 16 in. of belt take-up.
BEARINGS - Sealed,
pre-lubricated, self-aligning, ball bearings on drive, tail, and take-up
pulleys. Pre-lubricated ball bearings in tread and pressure rollers.
SPEED REDUCTION - Sealed
worm gear C-Face speed reducer. No. 50 roller chain to drive pulley.
MOTOR - 1/2
HP - 230/460V
- 3 Ph.
- 60 Hz. Totally Enclosed
C-Face.
BELT SPEED - Constant
65 FPM.
CAPACITY - Maximum
load per linear foot of conveyor 200 lbs. NOT TO EXCEED capacity in chart.
FLOOR SUPPORTS - Now
supplied as optional equipment. |
